Mitsubishi Electric MELDAS C6 Parameter Manual page 73

# Items
6. Axis Specifications Parameters
6.1 Axis Specifications Parameters
Details
(Continued from the previous page)
Cutting feed acceleration and deceleration types
LC: Linear acceleration/deceleration
C1: Primary delay
C3: Exponential acceleration and linear
deceleration
(Note) Designate "F" with bits 4 to 7 for cutting feed
with acceleration/deceleration by software.
Note that the acceleration/deceleration by
software will not applied on such case as
follows;
(1) AS for G01/G02/G03 command during
G61.1 modal, s-curve acceleration/
deceleration before interpolation is
applied to.
(2) Linear acceleration/deceleration is applied
to the cutting feed during synchronous
tapping.
<Combination of acceleration and deceleration
patterns>
R1 > R3 when both R1 and R3 contain 1.
<Stroke end stop types>
Type
Linear deceleration
Position loop step stop
Speed loop step stop
Position loop step stop
OT1 0 Deceleration by G0t1
Deceleration by 2 × G0t1
1
(Continued on the next page)
67
Get other manuals https://www.bkmanuals.com
OT2 OT3
0 0
1 0
0 1
1 1
Setting range
(unit)