Mitsubishi Electric MELDAS C6 Parameter Manual page 235

No. Items
3403 SP203 FFC4 Synchronized
(PR) tapping
acceleration
feed forward
gain
(gear 4)
3404 SP204
to to
3413 SP213
3414 SP214 TZRN Synchronized
tapping
zero point
return speed
3415 SP215 TPDT Synchronized
tapping
zero point
return
deceleration
rate
3416 SP216 TPST Synchronized
tapping
zero point
return shift
amount
3417 SP217 TINP Synchronized
tapping
in-position
width
3418 SP218 TODR Synchronized
(PR) tapping
excessive
error width
3419 SP219 IQGT Synchronized
(PR) tapping current
loop gain
magnifi-
cation 1
3420 SP220 IDGT Synchronized
(PR) tapping current
loop gain
magnifi-
cation 2
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
Set the acceleration feed forward gain for
selection of gear 011 during synchronized
tapping.
Not used. Set to "0".
This parameter is valid when SP193
(SPECT) bitE is set to "0".
Set the zero point return speed used when
the speed loop changes to the position
loop.
This parameter is valid when SP193
(SPECT) bitE is set to "0".
Set the deceleration rate where the
machine starts to decelerate when it
returns to the target stop point during
synchronized tapping zero point return.
When the machine tends to overshoot at
the stop point set a smaller value.
This parameter is valid when SP193
(SPECT) bitE is set to "0".
Set the synchronized tapping zero point
position.
Set the position error range for output of the
in-position during synchronized tapping.
Set the excessive error width during
synchronized tapping.
Set the magnification of current loop gain
(torque component) during synchronized
tapping.
Set the magnification of current loop gain
(excitation component) during
synchronized tapping.
229
Get other manuals https://www.bkmanuals.com
Details
Setting Standard
range setting
0 to 1000 0
(%)
0 0
0 to 500 50
(r/min)
0 to 10000 1
(pulse)
0 to 4095 0
1 to 2880 16
(1/16°)
1 to 32767 32767
(pulse)
(1 pulse
=0.088°)
1 to 1000 100
(%)
1 to 1000 100
(%)