Axis Parameters - Mitsubishi Electric MELDAS C6 Parameter Manual

2.4 Axis Parameters

# Item
8201 AX. RELEASE
8202 OT-CHECK OFF
8203 OT-CHECK-CANCEL When the simple absolute position method ("#2049
8204 OT-CHECK-N
8205 OT-CHECK-P
8206 TOOL CHG. P
8207 G76/87 IGNR
(For M system only)
2. Machining Parameters
2.4 Axis Parameters
Contents
Select the function to remove the control axis from
the control target.
0: Control as normal
1: Remove from control target
Select the stored stroke limit function set in #8204
and #8205.
0: Stored stroke limit valid
1: Stored stroke limit invalid
type" is 9) is selected‚ the stored stroke limits I, II (or
IIB) and IB will be invalid until the first reference
point return is executed after the power is turned on.
0: Stored stroke limit II valid (according to #8202)
1: Stored stroke limit II invalid
(Note) This setting (#8203) affects all the stored
stroke limits.
Set the coordinates of the (–) direction in the
moveable range of the stored stroke limit II or the
lower limit coordinates of the prohibited range of
stored stroke limit IIB.
If the sign and value are the same as #8205 (other
than "0"), the stored stroke limit II (or IIB) will be
invalid.
If the stored stroke limit IIB function is selected, the
prohibited range will be between two points even
when #8204 and #8205 are set in reverse.
When II is selected, the entire range will be
prohibited.
Set the coordinates of the (+) direction in the
moveable range of the stored stroke limit II or the
upper limit coordinates of the prohibited range of
stored stroke limit IIB.
Set the coordinates of the tool change position for
G30. n (tool change position return).
Set with coordinates in the basic machine coordinate
system.
Select the shift operation at G76 (fine boring) and
G87 (back boring).
0: Shift effective
1: No shift
7
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0/1
0/1
0/1
–99999.999 to
+99999.999 (mm)
–99999.999 to
+99999.999 (mm)
–99999.999 to
+99999.999 (mm)
0/1