Mitsubishi Electric MELDAS C6 Parameter Manual page 33

# Items
1100 Tmove Tool wear
compen-
sation
1101 Tabsmv Tool wear
compen-
sation
method
1102 tlm Manual tool
(For L length
system measuring
only) system
1103 T_life Validate life
management
1104 T_Com2 Tool
command
method 2
5. Base Specifications Parameters
Details
Specify the period to perform tool length offset and
wear compensation.
0: Compensate when T command is executed.
1: Superimpose and compensate with the
movement command in the block where the T
command is located. If there is no movement
command in the same block‚ compensation will
be executed after the movement command is
superimposed in the next movement command
block.
2: Compensate when the T command is executed.
1: Superimpose and compensate a tool length
offset with the movement command in the same
block. If there is no movement command in the
same block, compensation will be executed after
the movement command is superimposed in the
next movement command block.
Specify the type of movement command when "#1100
Tmove" is set to 1.
0: Compensate regardless of the movement
command type.
1: Compensate only at the movement command in
the absolute value command.
Specify the measurement method for manual tool
measurement l.
0: Align tool with basic position
1: Input measurement results
Select the usage of the tool life management function. 0: Do not use.
Select the command method for when "#1103 T_Life"
is set to 1.
0: Handle the program tool command as the group
No.
1: Handle the program tool command as the tool
No.
27
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0 to 2
0: Compensate
regardless of
the command
type.
1: Compensate
only with the
absolute value
command.
0: Basic position
method
1: Measured
value input
method
1: Perform tool life
management
control.
0/1