Mitsubishi Electric MELDAS C6 Parameter Manual page 57

# Items
1229 set01 Radius
(bit2) compen-
sation type B
(For M
system only)
Nose R
compen-
sation type B
(For L
system only)
set01 Initial
(bit3) constant
surface
speed
set01 Synchronous
(bit4) tap
set01 Start point
(bit5) alarm
set01 Grid display
(bit6) selection
1230 set02
1231 set03
1232 set04
1233 set05
5. Base Specifications Parameters
Details
0: When the start-up and cancel commands are
operated during radius compensation, their blocks
are not handled by intersection operation
processing; they are handled as offset vectors in the
direction vertical to that of the commands.
1: When the start-up and cancel commands are
operated during radius compensation, the inter-
section operation processing of the command
block and the next block is executed.
0: When the start-up and cancel commands are
operated during nose R, their blocks are not
handled by intersection operation processing; they
are handled as offset vectors in the direction
vertical to that of the commands.
1: When the start-up and cancel commands are
operated during nose R, the intersection operation
processing of the command block and the next
block is executed.
0: The initial state after power-on is a constant
surface speed control cancel mode.
1: The initial state after power-on is a constant
surface speed control mode.
0: Handles the tap cycles as the tap cycles with a
floating tap chuck.
1: Handles the tap cycles as the tap cycles without a
floating tap chuck.
Select an operation when the operation start point
cannot be found while moving the next block of G117.
0: Enables an auxiliary function after the block has
been moved.
1: Outputs a program error (P33) when the
operation start point is not found.
Select a grid type to be displayed on the servo monitor
screen during dog type reference point return.
0: Selects the distance between dog ON and
reference point (including a grid mask amount).
1: Selects a value given by reducing a grid mask
amount from the distance between dog ON and
reference point.
Not used.
Not used.
Not used.
Not used.
51
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0/1
0/1
0/1
0/1
0/1
0/1