Mitsubishi Electric MELDAS C6 Parameter Manual page 183

# Items
Synchronized
3037 tapt 21
tapping
3038 22
Switching
3039 23
spindle rota-
3040 24
tion speed 2
Synchronized
3041 tapt 21
tapping
3042 22
Switching time
3043 23
constant 2
3044 24
3045 tapt 31 Synchronized
tapping
3046 32
Switching time
3047 33
constant 3
3048 34
Spindle
3049 spt
synchroniza-
tion
acceleration/
deceleration
time constant
3050 sprlv Spindle
synchroniza-
tion rotation
speed
attainment
level
3051 spplv Spindle phase
synchroniza-
tion attainment
level
3052 spplr Spindle motor
spindle relative
polarity
3053 sppst Spindle
encoder
Z -phase
position
8. Spindle Parameters
8.1 Spindle Base Specifications Parameters
Set the spindle rotation speed at which the step-2
acceleration/deceleration time constant is to be
switched at gear 00, 01, 10, or 11.
Set the time constant to reach Synchronized tapping
switching spindle rotation speed 2 (#3037 to #3040) at
gear 00, 01, 10, or 11.
Set the time constant to reach the maximum rotation
spindle speed (#3005 to #3008) at gear 00, 01, 10, or
11.
Set the acceleration/deceleration time constant for
when the spindle synchronization command's rotation
speed changes during spindle synchronous control.
The spindle rotation speed synchronization complete
signal will turn ON when the difference of the
reference spindle and synchronous spindle actual
rotation speeds is less than the level set for the
synchronous spindle rotation speed command value
during spindle synchronous control.
The spindle phase synchronization complete signal
will turn ON when the phase difference of the
reference spindle and synchronous spindle is less
than the set level during spindle phase
synchronization control.
Set the spindle motor and spindle's relative polarity.
Spindle CW rotation at motor CW rotation
Spindle CCW rotation at motor CW rotation
Set the deviation amount from the spindle's reference
position to the spindle encoder's Z phase.
The deviation amount is obtained using the clockwise
direction looking from the front of the spindle as the
positive direction.
177
Get other manuals https://www.bkmanuals.com
Details
: Positive polarity
: Negative polarity
Setting range
(Unit)
0 to 99999
(r/min)
1 to 5000 (ms)
1 to 5000 (ms)
0 to 9999 (ms)
0 to 4095 (pulse)
(1 pulse =
0.088°)
0 to 4095 (pulse)
(1 pulse =
0.088°)
0: Positive
polarity
1: Negative
polarity
0 to 359999
(1/1000°)