Mitsubishi Electric MELDAS C6 Parameter Manual page 18

# Item
9116 TIME-OUT (s)
9216
9316
9416
9516
9117 DR OFF
9217
9317
9417
9517
9118 DATA ASC II
9218
9318
9418
9518
9119 INPUT FORM
9219
9319
9419
9519
EIA CODE [
9121
9221
9321
9421
9521
]
9122
9222
9322
9422
9522
#
9123
9223
9323
9423
9523
∗
9124
9224
9324
9424
9524
3. I/O Parameters
3.2 I/O Device Parameters
Contents
Set the time out time to detect an interruption in
communication.
The time out is not checked when 0 is set, so the
waiting time will be infinite.
The screens cannot be changed during the waiting
time.
Set this time to 10 as the standard.
Specify whether to check the DR data at the data
input/output.
0: Output in ISO/EIA code (Depends on whether
#9113, #9213, #9313, #9413, or #9513 EIA
output parameter is set up)
1: Output in ASC II code
Specify the mode for input (collation).
0: Standard input (Data from the very first EOB is
handled as significant information.)
1: EOBs following the first EOB of the input data
are skipped until data other than EOB is input.
When outputting with the EIA codes, special ISO
codes not included in EIA can be output with
alternate codes.
For each special code, designate a code (as a
hexadecimal) that is not duplicated with existing EIA
codes.
(Continued on the next page.)
12
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0 to 30 (s)
0: DR valid
1: DR invalid
0/1
0/1
0 to FF (hexadecimal)