Model Ifp-300Ecs Basic Operating Instructions - Honeywell Farenhyt Series Manual

Operation
Silence Alarms and Troubles Press SILENCE and then enter a code if prompted. The Silence LED will light.
Reset Alarms
View all active alarm, trouble,
and supervisory signals
View Point Status
Conduct a Fire Drill
Set Time and Date
Enable / Disable a Point
To Gain / Request ECS Control
For Service Call:

Model IFP-300ECS Basic Operating Instructions

These Instructions must be framed and displayed next to the IFP-2100ECS panel in accordance with NFPA 72
fire code for Local Protected Fire Alarm Systems. Test the system in accordance to NFPA 72.
1. Press RESET and then enter a code if prompted.
2. Press 1 to reset the Fire System or 2 to reset the Emergency Communication
System.
To reset the ECS at an LOC, the user must gain ECS Control (See Figure 1).
The highest priority event will display first. Press the Down arrow to view location and
type of alarm or trouble.
FIRE: ALARM SUPERVISORY TROUBLE
EMERGENCY: ALARM SUPERVISORY
SYSTEM: TROUBLE
1. Login to the panel.
2. Press 2 to select Point Functions.
3. Press 2 to select Point Status.
4. Select the desired module by using the Up or Down button. Then press ENTER.
5. Enter the point number.
Hold the DRILL button and then enter a code if prompted. OR
1. Login to the panel.
2. Then Press 1 to select System Tests.
3. Press 1 to select Fire Drill.
4. Press ENTER to start the fire drill. Press ENTER to end the fire drill.
1. Login to the panel.
2. Press 4 to select Set Time & Date.
3. Make changes in the fields on the screen as necessary.
4. When the time and date are correct, press ENTER.
1. Login to the panel.
2. Press 2 to select Point Functions.
3. Press 1 for Disable / Enable Pt
4. Press 7 for Disable / Enable Pt.
5. Use the Up or Down button to move through the list. Then press ENTER to select
the module where the desired point is located.
6. Enter the point or circuit number that you want to disable/enable.
7. Press the right arrow key to toggle between NORMAL (enable) or DISABLE.
Press the ECS Control Button and follow the on-screen Instructions.
When the ECS Control LED is blinking, another LOC has ECS Control. The ECS
Control LED is on steady when the LOC has ECS Control.
Task to Perform
CO: ALARM SUPERVISORY
P/N LS10163-001SK-E Rev B ECN: 151770