Installing The Cable Management Frames - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Installing the Cable Management Frames

Installing the Cable Management Frames
After you have fully installed the Cisco Nexus 7009 switch chassis in the rack or cabinet (see the
the Chassis, on page
When you install the cable management frames, you attach two side frames to the front-mount brackets on
the chassis and then attach a top hood to the top of the two side frames and the chassis.
Note
To install the cable management frames on the Cisco Nexus 7009 switch chassis, follow these steps:
SUMMARY STEPS
1. Attach a cable management frame (part number 800-33786) onto the two hooks that protrude from the
lower half of the left front-mount bracket that is attached to the Cisco Nexus 7009 switch chassis, and
loosely fasten the frame to the chassis with four flat-head M4x10 screws as shown in .
2. Repeat Step 1 to attach a cable management frame to the right side of the chassis.
3. Place the top hood (part number 800-33785-01) on top of the two cable management frames that are
already installed. Push the top hood toward the chassis so that its alignment pins enter the alignment holes
and the top hood rests against the chassis as shown in .
4. Use four M4x8 pan-head screws to loosely fasten the top hood to the chassis as shown in .
5. Use four M4x8 pan-head screws to loosely fasten the top hood to each of the two cable management
frames as shown in .
6. Tighten each of the four screws that fasten the top hood to the cable management frames to 11 to 15 in-lb
(1.2 to 1.7 N·m).
7. Tighten each of the eight screws that fasten the cable management frames to the rack-mount brackets to
11 to 15 in-lb (1.2 to 1.7 N·m).
DETAILED STEPS
Step 1 Attach a cable management frame (part number 800-33786) onto the two hooks that protrude from the lower half of the
left front-mount bracket that is attached to the Cisco Nexus 7009 switch chassis, and loosely fasten the frame to the
chassis with four flat-head M4x10 screws as shown in .
1 Cable management frame.
2 Front-mount bracket.
Step 2
Repeat Step 1 to attach a cable management frame to the right side of the chassis.
Step 3 Place the top hood (part number 800-33785-01) on top of the two cable management frames that are already installed.
Push the top hood toward the chassis so that its alignment pins enter the alignment holes and the top hood rests against
the chassis as shown in .
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
58
47), you can install the cable management frames on the front of the chassis.
Chassis with center-mount brackets include front-mount brackets for holding the cable management frames.
3 Position the frame so that the two lower hooks on the front-mount bracket fit inside the
two holes on the frame and then slide the assembly down so that it is held by the hooks.
4 Loosely fasten the assembly to the front-mount bracket with four M4x10 screws. Do not
tighten these screws.
Installing a Cisco Nexus 7009 Chassis
Installing