Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 90

Installing the Chassis
Push the lower half of the front side of the chassis so that the back side enters the rack first, and push until the chassis
mounting brackets come in contact with the front vertical mounting rails on the rack.
Figure 35: Moving a Cisco Nexus 7010 Chassis onto a Rack
1 Push the lower half of the front side of the chassis
2 Chassis mounting brackets
Step 4
Make sure that the screw holes in the chassis mounting brackets align with the screw holes in the vertical mounting rails.
If you need to reposition the chassis to align the screw holes, you can use the handles on the sides of the chassis.
Tip To adjust the placement of the chassis so that the screw holes in the chassis mounting brackets align with the
screw holes in the vertical mounting rails, use the chassis handles shown in
Nexus 7010 Chassis to the Rack, on page
Step 5
Use a Phillips screwdriver to screw in four M6 x 19-mm or 12-24 x 3/4-inch screws in each of the two chassis mounting
brackets (use a total of eight screws for two mounting brackets) as shown in
Chassis to the Rack, on page
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
78
3 Rack vertical mounting rails
79.
79.
Installing a Cisco Nexus 7010 Chassis
Figure 36: Attaching the Cisco
Figure 36: Attaching the Cisco Nexus 7010