Cisco Nexus 7010 System - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Cisco Nexus 7010 System

• Starting with Cisco NX-OS Release 8.0(1), the following I/O modules are not supported:
You must install the Cisco Nexus 7009 chassis in a two- or four-post 19-inch EIA rack that meets the following
specifications:
• Mounting rails that conform to the English universal hole spacing as specified in ANSI/EIA-310-D-1992.
• The minimum vertical rack space is 24.5 inches (62.2 cm) or 14 rack units (RU) for a single chassis
Install the Cisco Nexus 7009 chassis at the lowest possible RU on the rack for stability. If there are other
devices in the rack, install the heaviest chassis below the lighter chassis.
Danger
Cisco Nexus 7010 System
The Cisco Nexus 7010 chassis has 10 slots that allow for two supervisor modules and up to eight I/O modules.
Additionally, the chassis holds up to five fabric modules, two system fan trays, two fabric fan trays, up to
three power supplies, and cable management frames. The chassis also has mounting brackets and four
positioning handles (two on each side) that you use to install the chassis after you position it on a rack.
Optionally, you can include an air filter and mid-frame doors.
Figure 4: Standard Hardware Features on the Front and Sides of the Cisco Nexus 7010 Chassis, on page 9
identifies the standard features on the front and sides of the Cisco Nexus 7010 chassis,
Hardware Features on the Front Side of the Cisco Nexus 7010 Chassis, on page 10
features on the front side of the chassis, and
rear of the chassis.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
8
• 32-port 10-Gigabit Ethernet I/O modules with FEX support (N7K-M132XP-12)
• 48-port 1-Gigabit Ethernet I/O modules (N7K-M148GS-11)
• 48-port 1-/10-Gigabit SFP+ (N7K-F248XP-25)
• 48-port 10/100/1000 with XL option (N7K-M148GT-11L)
• 48-port 1-Gigabit Ethernet with XL option (N7K-M148GS-11L)
• 32-port 10-Gigabit Ethernet with XL option and FEX support (N7K-M132XP-12L)
• 8-port 10-Gigabit Ethernet with XL option (N7K-M108X2-12L)
installation (15 RU if you use the bottom support rails, which are required for center-mount installations
and optional for front-mount installations).
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. Statement
1048
Cisco Nexus 7010 System identifies the standard features on the
Overview
Figure 5: Optional
identifies the optional