Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 72

Installing the Front Door and Air Intake Frame
9.
10.
11.
12. While holding the door on the hinge pins with one hand, use your other hand to press the locking button
13. Open the door handle on the open side of the door until it clicks. This action opens the latches on the
14. Swing the door closed so that the unused hinge pins fit inside the slots on the top and bottom of the
DETAILED STEPS
Step 1
Position the left door stop on the middle of the left cable management frame and fasten it with two M3x10 pan-head
screws as shown in
to 0.8 N·m).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
60
Fasten the captive screws on the air-intake frame to the chassis and tighten to 11 to 15 in-lb (95 to 130
N·m).
On the chassis door, pull the door handle open on one of the two sides of the door until the handle clicks
(the handle clicks when you pull it about 30 degrees).
Move the side of the door with the opened handle onto the two hinge pins as shown in . Make sure that
the top and bottom hinge pins on the hood and hinge bracket fit through the slots on the top and bottom
of that side of the door. Position the door so that the hinge pins are located at the ends of the slots.
on the interior side of the door. See
action locks the latches around the hinge pins so that you no longer need to hold the door onto the
chassis.
open side of the door. See .
door. When you close the door, the door stopper automatically presses the lock button on the inside of
the door so that the door is locked on the hinge pins. If the door stopper does not close the latches, press
the door closed at the handle until you hear the latches click. Make sure that the door is fully secured
to the frames on both sides.
Figure 27: Attaching the Left Door Stop, on page
Figure 31: Attaching the Left Side of the Door, on page
61. Tighten these two screws to 5 to 7 in-lb (0.6
Installing a Cisco Nexus 7009 Chassis
65. This