Installing Storage Media In A Supervisor Module - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Installing a Cisco Nexus 7010 Chassis

Installing Storage Media in a Supervisor Module

Figure 41: ESD Grounding Port on the Rear of the Cisco Nexus 7010 Chassis
1 ESD grounding port
Installing Storage Media in a Supervisor Module
Each supervisor module on a Cisco Nexus 7000 Series switch is shipped with a CompactFlash card installed
in the LOG FLASH reader (Supervisor 1 modules) or a USB drive installed in the LOG FLASH reader
(Supervisor 2 and Supervisor 2E modules). The EXPANSION FLASH reader (Supervisor 1) or Slot0 port
(Supervisor 2 and 2E) is left empty, but you can optionally install a card in that reader or a USB drive in the
USB port. To allow this storage media to function with the reader or port, you must make sure that it is either
formatted for the reader before installing it or format it after installing it.
Note
The LOG FLASH and EXPANSION FLASH or Slot0 readers require different formats for their storage media.
To replace an installed CompactFlash card, see the "Replacing Storage Media for a Supervisor Module"
section on page 10-61 .
To install storage media in a supervisor module, follow these steps:
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
84