Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 123

Installing a Cisco Nexus 7018 Chassis
Figure 56: Attaching a Left Cable Management Assembly to a Rack-Mount Bracket
1 Rack-mount bracket.
2 Upper cable management
assembly.
Step 4
Repeat Step 3 to attach an upper cable management assembly to the upper right side of the chassis. When completed,
the chassis will appear as shown in
on page 112.
3 Position the assembly so that the two upper hooks on the rack-mount bracket
fit inside the two holes on the assembly, and then slide the assembly down so
that it is held by the hooks.
4 Loosely fasten the assembly to the rack-mount bracket with four M4x10
screws. Do not tighten these screws.
Figure 57: Cable Management Assemblies Attached to the Rack-Mount Brackets,
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Cable Management Frame
111