Supervisor Module Leds - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Supervisor Module LEDs

LED
FAB
IOM

Supervisor Module LEDs

Table 64: Supervisor Module LEDs , on page 244
Table 64: Supervisor Module LEDs
LED
STATUS
ID
SYSTEM
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
244
Color
Green
Amber
Green
Amber
Status Description
Green All diagnostics pass. The module is operational (normal initialization
sequence).
Red The module has detected a slot ID parity error and will not power on or boot
up.
or
The module is not fully inserted and does not have a reliable connection to
the midplane.
or
The diagnostic test has failed.
Flashing red The inlet air temperature of the system has exceeded the safe operating
temperature limits of the module (a major environmental warning). The
module has been shut down to prevent permanent damage. The system will
be shut down after two minutes if this condition is not cleared.
or
The module is resetting, and both ejector levers are out.
Off The module is not receiving power.
Flashing blue The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.
All chassis environmental monitors are reporting okay.
Green
Amber At least one power supply has failed or the power supply fan has failed.
Red The temperature of the supervisor engine major threshold has been exceeded.
Off The slot has detected a slot ID parity error.
Condition
Fabric modules are all operational.
At least one fabric module has a red STATUS LED.
The modules in the I/O slots are all operational.
At least one module in the I/O slots has a red STATUS LED.
describes the supervisor module LEDs.
Chassis and Module LEDs