Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 76

Installing the Front Door and Air Intake Frame
Figure 30: Positioning the Air Intake Frame on the Chassis
1 Air intake
frame.
Step 9
Fasten the captive screws on the air-intake frame to the chassis and tighten to 11 to 15 in-lb (95 to 130 N·m).
Step 10 On the chassis door, pull the door handle open on one of the two sides of the door until the handle clicks (the handle
clicks when you pull it about 30 degrees).
Step 11 Move the side of the door with the opened handle onto the two hinge pins as shown in . Make sure that the top and
bottom hinge pins on the hood and hinge bracket fit through the slots on the top and bottom of that side of the door.
Position the door so that the hinge pins are located at the ends of the slots.
Note The double-hinge door can be installed and opened on either side. The figures in this procedure show how
to install the door on the left side first, but you can use the instructions to install it on either side.
1 Double-hinged door
2 Move one side to the hinge pins
Step 12
While holding the door on the hinge pins with one hand, use your other hand to press the locking button on the interior
side of the door. See
the hinge pins so that you no longer need to hold the door onto the chassis.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
64
2 Align captive screws to their holes in the chassis and fasten them to the chassis.
3 Hinge pins
4 Slot for hinge
pin
Figure 31: Attaching the Left Side of the Door, on page
Installing a Cisco Nexus 7009 Chassis
65. This action locks the latches around