Nam-Nx1 Module Leds - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Chassis and Module LEDs
LED Status
Status Green
Red
Flashing red
Off
Link (for each Green
port)
Orange
Flashing orange
Off

NAM-NX1 Module LEDs

Table 66: NAM-NX1 LEDs, on page 248
Description
All diagnostics pass. The module is operational (normal initialization sequence).
The module has detected a slot ID parity error and will not power on or boot up.
or
The module is not fully inserted, and it is not making a reliable connection with the supervisor.
or
The module has failed diagnostic tests and has powered down.
While reloading an F3-Series or M3-Series I/O module, the status LED is Amber
Note
until the testing phase is complete. While reloading an F2e-Series or an M2-Series
I/O module, the status LED blinks RED until the testing phase is complete.
The switch has just been powered on, and the module is resetting.
or
The module is resetting and both ejector levers are out.
or
The module has been inserted during the initialization process.
or
The module could not power up because of insufficient power.
or
An overtemperature condition has occurred. A major temperature threshold has been exceeded
during environmental monitoring.
The module is not receiving power.
The port is active (the link is connected and active).
The port is disabled by the operator or is not initializing.
The port is faulty and disabled.
The port is not active or the link is not connected.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
describes the LEDs on the NAM-NX1.

NAM-NX1 Module LEDs

247