Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 88

Required Tools and Equipment
Warning
• Bottom-support rails installed in the rack or cabinet—You must already have two bottom-support rails
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions
to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• Cisco Nexus 7010 chassis and its components are accounted for and undamaged.
Required Tools and Equipment
You need the following tools and equipment to install the Cisco Nexus 7010 chassis:
• Mechanical lift capable of lifting at least 550 pounds (250 kg)
Caution
• Number 1 Phillips-head screwdriver with torque capability
• Bottom-support rails kit (shipped with the Cisco Nexus 7010 system accessory kit)
Part of this kit has already been used to install the bottom-support rails.
Kit, on page 76
Table 6: Contents for the Rack-Mount Kit
Part Description
12-24 x 3/4 in. Phillips screws
M6 x 19 mm Phillips screws
Adjustable bottom-support rails
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
76
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. Statement
1048
attached to the lowest possible rack unit on the chassis.
For more information, see the
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack. Statement 1006
For more information, see the
You must use a mechanical lift whenever lifting a device over 120 pounds (55 kg).
lists the items in the rack-mount kit.
Installing the Bottom-Support Rails on the Rack, on page
Unpacking and Inspecting a New Switch, on page
Quantity
20
20
2
Installing a Cisco Nexus 7010 Chassis
72.
71.
Table 6: Contents for the Rack-Mount