Installing The Chassis - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Installing a Cisco Nexus 7010 Chassis
Figure 34: Attaching a Bottom-Support Rail to a Rack
1 Four sets of 3 M6 x 19 mm Phillips screws orfour sets of 3 12-24 x 3/4 in.
Phillips screws

Installing the Chassis

This section describes how to install the Cisco Nexus 7010 chassis in a rack or cabinet. These installation
steps include transporting the chassis, elevating the chassis to the rack using a mechanical lift, pushing the
chassis onto the rack, and then securing the chassis to the rack.
This section includes the following topics:
Prerequisites for Installing the Chassis
Before you install the chassis, you must make sure that the following items are available for the installation:
• Data center ground is accessible where you are installing the Cisco Nexus 7010 chassis.
• Four-post, 19-inch EIA rack or cabinet that includes such a rack.
For more information on the rack or cabinet, see the Installing a Four-Post Rack or Cabinet, on page
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Chassis
2 Adjustable bottom-support rails (2)
70.
75