Supervisor Module Leds - Cisco Catalyst 9600 Series Hardware Installation Manual

Supervisor Module LEDs

LED Position or Colour
Solid Amber
1Hz Blinking Amber
2Hz Blinking Green
1Hz Blinking Green
Off
Supervisor Module LEDs
Table 12: LEDs and the Status
LED type
STATUS
BLUE BEACON
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
98
Meaning
Indicates one of the following:
• No output power available
• AC/DC input is below the operating range
• No 12V standby from a parallel unit is available
• Over voltage/over current/over temperature conditions
• Over-temperature protection (OTP) due to fan failure
Indicates warning events such as a power supply module that continues
to operate in high temperature or high power and a fan that runs slow
and so on.
Indicates that power switch is turned off with AC/DC input power
available or that the power supply is in standby mode.
Indicates bootloading mode.
Indicates one of the following:
• No input or output power available
• AC/DC input is below the operating range
• No 12V standby from a parallel unit
LED Position or Colour
Green
Amber
Red
Off
Solid blue
Meaning
Indicates that all diagnostic tests have passed after
image booting.
Indicates a major environmental warning.
Indicates a fault in the module due to parity error or
failed diagnostic tests or hardware failure.
Indicates that the supervisor module is disabled or is
not powered up.
Identifies the supervisor module receiving the beacon
signal.
LEDs