Cisco Nexus 7010 System - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Chapter 1 Overview
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the
Warning
floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip
over. Statement 1048

Cisco Nexus 7010 System

The Cisco Nexus 7010 chassis has 10 slots that allow for two supervisor modules and up to eight I/O
modules. The chassis also holds up to five fabric modules, two system fan trays, two fabric fan trays, up
to three power supply units, and a cable management system. The chassis also has a mounting bracket
and four positioning handles (two on each side) that you use to install the chassis after you position it
on a rack. Optionally, you can include an air filter and mid-frame doors.
Figure 1-3
Figure 1-4
standard features on the rear of the chassis.
Figure 1-3
OL-23069-06
identifies the standard features on the front and sides of the Cisco Nexus 7010 chassis,
identifies the optional features on the front side of the chassis, and
Standard Hardware Features on the Front and Sides of the Cisco Nexus 7010 Chassis
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Cisco Nexus 7000 Series
Figure 1-5 identifies the
1-5