RA-100 Remote Annunciator Installation
Figure 4.15 illustrates Class B configuration.
Wire the Annunciator board to the main control panel. See Figure 4.15.
3.
Attach the annunciator and door assembly to back box as shown in Figure 4.16 using the supplied screws.
Surface Mounting
The optional Model RA-100TG/TR Trim Ring Kit is available for use when surface mounting.
1.
Remove the desired knock outs. See Figure 4.14.
2.
To mount the back box, insert a single screw into the key shaped mounting hole. Do not tighten all the way. See Figure 4.17.
IFP-75/IFP-75HV Installation/Operation Manual — P/N LS10147-001SK-E:D 06/25/2021
i
k
k
t
Figure 4.14 Back Box Knockout Locations
Figure 4.15 SBUS Class B Wiring
Figure 4.16 Attaching Annunciator/Door Assembly to Backbox
wire knockouts
Control Panel Installation
wire knockouts
supervised
power-limited
33