Table of Contents
Advertisement
Network Management
Profile Edit Menu
From the Profile Edit Menu, you can change the User's Name, Access Code, and the panel functions to which the user will have access with
their code.
NOTE: In Profile 1 (Fire Fighter's Key), the User Name and Access Code cannot be edited.
- In Profile 2 (Installer), the User Name and the panel functions cannot be edited.
- In Profile 3 (Multi-Site Installer), it is defaulted with the Multi-Site Access option, but the entire profile can be edited.
Edit Name
6.
See Appendix B for a list of available characters and their numeric designators.
7.
Then, press ENTER to finish.
Edit Access Code
8.
Enter the new Access Code (minimum of 4 digits, maximum of 7 digits).
9.
Press ENTER.
10. Enter the code again. Then, press ENTER.
Panel Functions
11. Press the up or down arrow key to move the cursor through the list of available functions.
12. Then, press the right arrow to move the cursor to Y (yes) or N (no) selection column.
13. Press the up or down arrow key to select Y or N.
14. Press ENTER.
15. Repeat Steps 12 through 15 until the User Profile is complete.
6.2.6 Communicator Options
The Communicator options provide the configuration for reporting events to a Central Station.
1.
From the Main Menu, do the following.
2.
Select 6 to access the Network Programming.
3.
Press 6 to enter Communicator Options Menu.
Communicator Assignments
Each panel in the Network System specifies which Network Communicator is used for reporting. The Network Communicator capability of
the linked System allows all panels to use the same Communicator providing an economical solution for reducing the number of paths
required for reporting purposes. A Communicator is specified by the panel number. Use the Network Communicators to report events
according to the Communicator Report table.
Communicator Miscellaneous
When you use the SIA Reporting Format, the Communicator sends information according to the SIA Reporting Type.
The selections for this option are as follows:
•
pi modifier (default)
•
Panel ID*
NOTE: *Only the SIA sends the Panel ID when reporting.
Receiver Configuration
The Network System can report events to as many as 68 receivers. See Appendix C for a list of the panel/receiver relationship numbers. Each
receiver can be assigned the reporting credentials. When you use a format that supports phone numbers, the format can be up to forty digits
long.
1.
From the Main Menu, do the following.
2.
Select 6 to access the Network Programming.
3.
Press 6 to enter Communicator Options Menu.
4.
Select 3 to access the Receiver Configuration.
5.
Select Panel to Program and press ENTER.
6.
Enter the Receiver Number to which you want to report. The Receiver Numbers available will correspond with the Panel Number you
entered. The Receiver Numbers are populated based on the Panel Number and audited to allow only the 4 appropriate receivers. See
Appendix C for a list of Receiver Numbers.
Table 6.2 lists the available Format choices:
62
Reporting Format
Contact ID
SIA500
SIA8
SIA20
Ethernet
Cellular
eVance
UNUSED
Table 6.2 Receiver Configuration
IFP-75/IFP-75HV Installation/Operation Manual — P/N LS10147-001SK-E:D 06/25/2021
Network Programming
Advertisement
Table of Contents
Troubleshooting
