Table of Contents
Advertisement
Mounting the Control Panel Cabinet
4.1.3 Dead Front Installation and Removal
This section provides instructions to install and/or remove the optional dead-front (DF-50) for the control panel cabinet.
Installing the Dead Front
Follow these steps to properly install the dead front panel into the control panel cabinet.
1.
Remove the top, two annunciator screws, do not discard them they will be reused. See Figure 4.2 for annunciator screw location.
2.
Set the dead-front into the cabinet as shown in Figure 4.2.
3.
Reinsert the two annunciator screws.
.
4.
Insert the two screws with the star washers into the bottom of the cabinet to secure the dead front into place. See Figure 4.2.
Dead Front Removal
Follow these steps to properly remove the dead front panel from the control panel cabinet.
1.
Remove the two annunciator screws, do not discard them. See Figure 4.2.
2.
Remove the two screws and star washers from the bottom of the cabinet. See Figure 4.2.
3.
Remove the dead front panel from the control panel cabinet.
4.
Reinsert the two annunciator screws. See Figure 4.2.
IFP-75/IFP-75HV Installation/Operation Manual — P/N LS10147-001SK-E:D 06/25/2021
Figure 4.2 Dead Front Installation and Removal
Dead Front
Panel
Control Panel Installation
25
Advertisement
Table of Contents
Troubleshooting
