Draytek Vigor2860 User Manual page 928

Parameter
[<command>
<parameter>|...]
-e <1/0>
-l <1/0>
-M <1/0>
-v <1-255>
-R
-p <1-30>
-k <key>
-u <1/0>
-m <interface>
-s
-y
-c <1/0>
-I -[M|H|D] <interval>
-h -<4/6><Subnet> [<Virtual
IP>]
-d -<4/6><Subnet>
-o <1/0>
914
Description
The available commands with parameters are listed below.
[...] means that you can type in several parameters in one line.
1: Enable the function of High Availability (HA).
0: Disable the function of High Availability (HA).
1: Enable the function of recording the operation record of HA in
Syslog.
0: Disable the function of recording the operation record of HA in
Syslog.
Specify the Redundancy Method for HA.
1: Active-Standby
0: Hot-Standby
Specify the group ID (VHID)
1- 255: Setting range.
Set HA settings to Factory Default.
Specify the Priority ID.
1-30: Setting range.
Specify the Authentication Key.
Key: Max. 31 Characters.
Enable or disable the function of Update DDNS.
1: Enable. When a router changes HA status to primary, it will
update DDNS automatically.
0: Disable.
Specify the management interface.
Interface: LAN1 ~ LAN6, DMZ.
It means to get the newest status of other router (except the local
router).
It means sync local config to other router. Primary can executes this
command. Secondary can not execute this commad.
Enable or disable the function of Config Sync.
1: Enable.
0: Disable.
Set the Config Sync Interval for HA. Minimum interval is 15 minutes.
-M: Minute. Setting range is 0/15/30/45. (e.g., ha set -I -M 30)
-H: Hour. Setting range is from 0 to 23. (e.g., ha set -I -H 12)
-D: Day. Setting range is from 0 to 30. (e.g., ha set -I -D 15)
Enable and set virtual IP to the subnet.
4: IPv4; 6: IPv6.
Subnet: LAN1 to LAN6, DMZ.
Virtual IP: The type format shall be "xxx.xxx.xxx.xxx". (e.g,
192.168.1.0)
For example, to enable a virtual IP to the sunet, simply type:
ha set –h LAN1 192.168.1.5
Disable a virtual IP to the subnet.
4: IPv4; 6: IPv6.
Subnet: LAN1 to LAN6, DMZ.
For example, to disable a virtual IP to the subnet, just type:
ha set –h LAN1
Run DARP protocol on IPv4 or IPv6.
0: IPv4
1: IPv6
Vigor2860 Series User's Guide