Draytek Vigor2860 User Manual page 906

rdate
enable/disable
thres [budget limit (MB)]
gthres [budget limit (GB)]
mode
[monthly|periodic|none]
psday [th day in periodic]
action [action bitmap]
status
E x a m p l
E x a m p
> wan budget wan 1 action 5
% WAN 1 budget action set to 5
> wan budget wan 1 gthres 10
% WAN 1 budget limit set to 10 GB
T e l n e t C o m m
T e l n e t C o m m
This command allows you to run a WAN MTU Discovery. The user can specify an IPv4 target to
ping and find the suitable MTU size of the WAN interface.
S y n t a x
S y n t a x
wan detect_mtu -w [number] -i [Host/IP address] -s [base_size] -d [decrease_size] (-c
[count])
S y n t a x
S y n t a x
Parameter
-w [number]
-I [Host/IP address]
-s [base_size]
-d [decrease size]
-c [count]
892
Specify the WAN budget refresh time.
day – Available settings are from 1 to 30.
hour – Available settings are from 1 to 23.
E.g., wan budget wan 1 rdate 5 10
If monthy mode is selected: WAN budget will be refreshed on 5th
day at 10:00 in each month
If periodic mode is selected: WAN budget will be refreshed every 5
days and 10 hours
enable - Enable the function of wan budget.
disable - Disable the function of wan budget.
Specify the maximum value for WAN budget limit. (Unit: MB)
budget limit – Type a number.
Specify the maximum value of wan budget limit. (Unit: GB)
budget limit – Type a number.
Specify the calculation mode (monthly, periodically, or none) for
WAN budget.
It is used only when mode is set with "periodic". Specify the order
of "today" in the cycle.
E.g., wan budget wan 5 psday  It means "today" is the 5
in the billing cycle.
Determine the action to be performed when it reaches the WAN
budget limit.
action bitmap – Type a total number of actions to be executed.
Different numbers represent different actions.
For example, if you type "5" (5=1+4), the system will send SMS alert
when WAN shotdown is detected.
Display current configuration status of WAN budget.
e
l e
a n d : w a n d e t e c t _
a n d : w a n d e t e c t _
D e s c r i p t i o n
D e s c r i p t i o n
Description
Specify the WAN interface.
Value: Type the number of WAN interface. 1: WAN1; 2:WAN2....and
etc.
Specify the IPv4 target to detect. If can be an IPv4 address or
domain name.
Host/IP address: Type the IP address/domain name of the target.
Set the MTU size base for Discovery.
base_size: Available setting is 1000 ~ 1500.
Set the MTU size to decrease between detections.
decrease size: Available setting is 1 ~ 100.
Set the maximum times of ping failure during a Discovery.
1: shotdown wan
2: send mail alert
4: send sms alert
m t u
m t u
th
Vigor2860 Series User's Guide
day