Draytek Vigor2860 User Manual page 738

AcquireIP: Dhcp_client(1)
Idle timeout:-1
Username=draytek
Password=draytek
T e l n e t C o m m
T e l n e t C o m m
This command can specify a LAN port (LAN1 to LAN4) for mapping to certain PVC, and the
mapping port/PVC will be operated in bridge mode.
S y n t a x
S y n t a x
adsl bridge [pvc_no/status/save/enable/disable] [on/off/clear/tag tag_no] [service type]
[px ... ]
S y n t a x
S y n t a x
P a r a m
P a r a m
pvc_no
status
save
enable
disable
on/off
clear
tag tag_no
pri pri_no
service type
px...
E x a m p l
E x a m p
> adsl bridge 4 on p2 p3
PVC Bridge
------------------------------------------------------------
4
PVC 0 & 1 can't set for bridge mode.
Please use 'save' to save config.
724
a n d : a d s l b r i d g e
a n d : a d s l b r i d g e
D e s c r i p t i o n
D e s c r i p t i o n
e t e r
e t e r
e
l e
p1 p2
ON 0 0
D e s c r i p t i o n
D e s c r i p t i o n
It means pvc number and must be between 0(Channel 1) to
7(Channel 8).
It means to shown the whole bridge status.
It means to save the configuration to flash.
It means to enable the Multi-VLAN function.
It means to disable the Multi-VLAN function.
It means to turn on/off bridge mode for the specific
channel.
It means to turn off and clear all the PVC settings.
No tag: -1
Available number for tag: 0-4095
The number 0 to 7 can be set to indicate the priority. "7" is
the highest.
Two number can be set:
0: for Normal (all the applications will be processed with
the same PVC).
1: for the IGMP with different PVC which is used for special
ISP.
It means the number of LAN port (x=2~4). Port 1 is locked for NAT.
p3 p4 Service Type
1 0 Normal
Tag Pri
-1(OFF) 0
Vigor2860 Series User's Guide