Draytek Vigor2860 User Manual page 498

TLS/SSL Encryption Setup
CVM Access Control
AP Management
Device Management
After finished the above settings, click OK to save the configuration.
F o r I P v 6
F o r I P v 6
Available settings are explained as follows:
484
Penalty period – Set a period of time to block the IP address
which is used (by user or hacker) for passing through the user
authentication again and again but failed always. When the
time is up, Vigor system will unblock that IP and allow it to
access into Vigor router again.
Blocked IP List – Open another web page which displays
current blocked IPs.
Enable SSL 3.0/1.0/1.1/1.2 – Check the box to enable the
function of SSL 3.0/1.0/1.1/1.2 if required.
Due to security consideration, the built-in HTTPS and SSL
VPN server of the router had upgraded to TLS1.x protocol. If
you are using old browser(eg. IE6.0) or old SmartVPN Client,
you may still need to enable SSL 3.0 to make sure you can
connect, however, it's not recommended.
CVM Port – Check the box to enable such port setting.
CVM SSL Port – Check the box to enable such port setting.
Enable AP Management – Check it to enable the function of
Central Management>>AP. If unchecked, menu items
related to Central Management>>AP will be hidden.
Check the box to enable the device management function for
Vigor2860.
Respond to external device – If it is enabled, Vigor2860 will
be regarded as slave device. When the external device
(master device) sends request packet to Vigor2860,
Vigor2860 would send back information to respond the
request coming from the external device which is able to
manage Vigor2860.
Vigor2860 Series User's Guide