Ii-4-12-2 Config Sync - Draytek Vigor2860 User Manual

Management Interface
Update DDNS
Syslog
LAN1 ~ LAN6, DMZ
When you finish the configuration, please click OK to save and exit this page.
I I - 4 - 1 2 - 2
I I - 4 - 1 2 - 2
This page is used to specify the synchronization time for such Vigor router and only available
when Hot-Standby method is specified and High Availability is enabled.
Available settings are explained as follows:
Item
Enable Config Sync (Max.
Sync to 10 routers)
Vigor2860 Series User's Guide
Such interface is used for DARP (DrayTek Address
Redundancy Protocol) negotiation between routers. Only the
interface which is enabled in LAN>>General Setup is
available for selection.
However, LAN1 is always enabled.
Enable – Check the box to update the DDNS server for the
secondary device if required.
If the primary device fails, and the secondary device must
take over the job of data transmitting and receiving. Then
the system will update the DDNS server to make the user
connect to the specified domain name.
Enable – Check the box to record required information on
Syslog.
Enable – Check the box to enable the interface.
Virtual IP - Type the IP address of the router plays the role of
Primary device.
C o n f i g S y n c
C o n f i g S y n c
Description
Check this box to enable configuration synchronization.
To sync configuration from primary to secondary router,
both primary and seconday routers need to enable "config
sync". Note that config sync can be enabled by Hot-Standby
213