Draytek Vigor2860 User Manual page 877

voip rtp dtmf
[index] [mode |
payloadtype][value]
voip rtp port
start|end
value
voip rtp symmetric
value
voip rtp tos
value
E x a m p l
E x a m p
> voip rtp codec 1 type 3
> voip rtp dtmf 2 mode 3
> voip rtp port start 10070 end 14400
Set start port: 10070
> voip rtp port end 14400
Set end port: 14400
> voip rtp symmetric 1
Set symmetric rtp to Enable
T e l n e t C o m m
T e l n e t C o m m
This command allows users to set SIP account.
S y n t a x
S y n t a x
Vigor2860 Series User's Guide
Vad - 0 means to Disable the function of Voice Active Detector
(vad); 1 means to Enable the function of Voice Active Detector
(vad).
One – 0 means to Disable the function of single codec; 1 means to
Enable the function of single codec.
Set the DTMF mode and Payload type for DTMF.
Index – SIP account index number. Available number, 1 ~ 12.
Mode – Four options to be selected.
Payloadtype – Available settings 96~127.
Value – Type 0~3 or 96~127 based on the mode specified.
For example,
Specifies the start/end port for RTP stream.
The default value is 10050/15000.
Make the data transmission going through on both ends of local
router and remote router not misleading due to IP lost.
1 – Enable
0 - Disable
Set the type of service (TOS) setting for RTP packets.
For example,
e
l e
a n d : v o i p s i p
a n d : v o i p s i p
1 means 20ms
2 means 30ms
3 means 40ms
5 means 60ms
0. Inband
1. Outband
2. SIP INFO (cisco)
3. SIP INFO (nortel)
> voip rtp dtmf 1 mode 1
> voip rtp tos 0x899
Set TOS: 0x899
863