Draytek Vigor2860 User Manual page 897

E x a m p l
E x a m p
> wan status
WAN1: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
Primary DNS=0.0.0.0, Secondary DNS=0.0.0.0
PVC_WAN3: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
PVC_WAN4: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
PVC_WAN5: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
T e l n e t C o m m
T e l n e t C o m m
This command, wan modem, allows you to configure 3G/4G USB Modem (PPP mode) of WAN3.
The command, wan modem2, allows you to configure 3G/4G USB Modem (PPP mode) of
WAN4.
S y n t a x
S y n t a x
wan modem [init/init2/dial/pin][string]
wan modem paponly [on/off]
wan modem backup_wait [value]
wan modem pipe [Int][Din][Dout] (for USB WAN3 only)
wan modem wakeup [on/off/value] (for USB WAN3 only)
wan modem vid [id]
wan modem pid [id]
wan modem status
S y n t a x
S y n t a x
Parameter
init
Init2
dial
pin
paponly
Vigor2860 Series User's Guide
e
l e
a n d : w a n m o d e m
a n d : w a n m o d e m
D e s c r i p t i o n
D e s c r i p t i o n
Description
Set initial modem AT command (default value is
"AT&FE0V1X1&D2&C1S0=0").
Set the second initial modem AT command.
Set dial modem AT command (default value is "ATDT*99#").
Set PIN code for SIM card.
"0":disable
It means PAP Only. Set the PPP authentication of the USB WAN.
/ w a n m o d e m 2
/ w a n m o d e m 2
883