Draytek Vigor2860 User Manual page 828

usblp_ptr=0
UsbPrintReady=0, UsbIsPrinting=0
T e l n e t C o m m
T e l n e t C o m m
This command allows user to set general settings for QoS.
S y n t a x
S y n t a x
qos setup [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-h
-m <mode>
-i <bandwidth>
-o <bandwidth>
-r <index:ratio>
-u <mode>
-p <ratio>
-t <mode>
-V
-D
[...]
E x a m p l
E x a m p
> qos setup -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
WAN1 QOS mode is both
Wan 1 is XDSL model ,don,t need to set up
Wan 1 is XDSL model ,don,t need to set up
WAN1 class 3 ratio set to 20
WAN1 udp bandwidth control set to enable
WAN1 udp bandwidth limit ratio set to 50
814
a n d : q o s s e t u p
a n d : q o s s e t u p
D e s c r i p t i o n
D e s c r i p t i o n
e
l e
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Type it to display the usage of this command.
It means to define which traffic the QoS control settings will apply
to and eable QoS control.
0: disable.
1: in, apply to incoming traffic only.
2: out, apply to outgoing traffic only.
3: both, apply to both incoming and outgoing traffic.
Default is enable (for outgoing traffic).
It means to set inbound bandwidth in kbps (Ethernet WAN only)
The available setting is from 1 to 100000.
It means to set outbound bandwidth in kbps (Ethernet WAN only).
The available setting is from 1 to 100000.
It means to set ratio for class index, in %.
It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.
It means to enable bandwidth limit ratio for UDP.
It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
Show all the settings.
Set all to factory default (for all WANs).
It means that you can type in several commands in one line.
Vigor2860 Series User's Guide