Draytek Vigor2860 User Manual page 900

read
reboot
reply
send
stus
tag
user
886
-n <number>: Set SMS quota. The avaible number is between 1 and
1000000.
-s <0/1>: Set whether to stop sending SMS after SMS quota
exceeded. (0: no 1: yes)
Display information of an SMS in the LTE SIM card by specifying the
index number. Use "all" to display all.
Set settings of Reboot on SMS Message function.
<command> <parameter> | ...
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
-a <0/1>: Enable or disable Access Control List. (0: disable 1:
enable)
-e <0/1>: Enable or disable Reboot on SMS Message function. (0:
disable 1: enable)
-p <password>: Set the Password / PIN. This setting is necessary if
this function is enabled.
-x <number>: Set the first phone number in Access Control List.
-y <number>: Set the second phone number in Access Control List.
-z <number>: Set the third phone number in Access Control List.
Set settings of Reply with Router Status Message function.
<command> <parameter> | ...
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
-a <0/1>: Enable or disable Access Control List. (0: disable 1:
enable)
-c <0/1>: Set whether to reply with MAC address. (0: no 1: yes)
-e <0/1>: Enable or disable Reboot on SMS Message function. (0:
disable 1: enable)
-f <0/1>: Set whether to reply with WAN1 IP address. (0: no 1: yes)
-g <0/1>: Set whether to reply with WAN2 IP address. (0: no 1: yes)
-h <0/1>: Set whether to reply with LTE WAN IP address. (0: no 1:
yes)
-i <0/1>: Set whether to reply with WAN4 IP address. (0: no 1: yes)
-j <0/1>: Set whether to reply with WAN1 data usage. (0: no 1: yes)
-k <0/1>: Set whether to reply with WAN2 data usage. (0: no 1: yes)
-l <0/1>: Set whether to reply with LTE WAN data usage. (0: no 1:
yes)
-m <0/1>: Set whether to reply with WAN4 data usage. (0: no 1: yes)
-n <0/1>: Set whether to reply with Router name. (0: no 1: yes)
-p <password>: Set the Password / PIN. This setting is necessary if
this function is enabled.
-u <0/1>: Set whether to reply with Router system uptime. (0: no 1:
yes)
-v <0/1>: Set whether to reply with Router firmware version. (0: no
1: yes)
-x <number>: Set the first phone number in Access Control List.
-y <number>: Set the second phone number in Access Control List.
-z <number>: Set the third phone number in Access Control List.
Send an SMS message to the specified phone number through the
LTE SIM card.
Display status of LTE connection.
Set an SMS in the LTE SIM card as read state by specifying the index
number. Use "all" to set all SMS as read state.
Set the UserName of LTE WAN.
Vigor2860 Series User's Guide