Software Setup - Honeywell Thor VM3 User Manual

First Boot
The first boot (also known as the Out of Box Experience) provides initial configuration of
the Thor VM3. When a Thor VM3 is ordered with a Windows 7 Professional or Windows
Embedded 7 operating system, the product key is printed on a decal on the rear of the
Thor VM3. It may be necessary to remove the Thor VM3 from the dock to view the prod-
uct key decal. Under normal circumstances, it is not necessary to re-enter the product
key as it was entered during the manufacturing process. If the Thor VM3 was ordered
without an operating system, a product key must be provided by the customer to acti-
vate Windows.
When a new Thor VM3 starts up a EULA (End User License Agreement) may be dis-
played on the touch screen. It remains on the screen until the Accept or Decline button
is tapped with a stylus.
Tap the Accept button to accept the EULA terms and the Thor VM3 continues the
startup process. The EULA is not presented to the user again.
Tap the Decline button to decline the EULA and the Thor VM3 reboots. It will continue
to reboot until the Accept button is tapped with the stylus.

Software Setup

Hardware setup should be completed before starting software setup.
1. If prompted, perform
2. Set
3.
4. Adjust
5. Configure
6. Set wireless client parameters using the
7. Set terminal emulation parameters.
8 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Date / Time if not set during first boot.
Select a Power Plan and set timers.
Speaker Volume.
Bluetooth
Touch Screen Calibration.
Printingand Bluetooth
WLAN Wireless Configuration Utility
Scanning.
(WCU).