Change Password - Honeywell Thor VM3 User Manual

•
Configuration Storage
Select the users to which the ZoomZome settings apply.
•
•

Change password

By default, no password is assigned to ZoomZone. If a password is set, the password
must be entered to access the ZoomZone user interface to view or change configuration
parameters.
To set a password:
1. Tap the Change Password button.
2. Enter the current password. If no password is assigned, leave this entry blank.
3. Enter and confirm the new password. To remove a previously set password, leave the
4. Tap OK to confirm changes or Cancel to discard changes.
Set Zoom Area
The ZoomArea can be selected from the current active desktop display. To set the zoom
area:
1. Display the desired content on the Thor VM3 desktop.
2. Open the ZoomZone interface.
3. Tap the Set Zoom Area button.
4. Select the desired zoom area by tapping on the upper left corner of the desired area
Note: Be sure to select the desired area from the upper left corner to the lower right. Selecting
the area from a different corner may result in nothing (a black box) being displayed.
5. If the selected area is not satisfactory, repeat the step above to reselect an area.
6. At the top of the display, tap File and select one of the available options:
178 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Delay on Stop - Configure the delay between motion stopping and the screen
resuming normal behavior. The default is 2 seconds.
Global Storage - The ZoomZone settings apply to all users of the Thor VM3.
Per User Storage - The ZoomZone settings only apply to the current user.
new password blank.
and dragging to the lower right corner of the desired area. The selected area is
highlighted by a red outline.
• Save - Saves the selected zoom area are returns to the ZoomZone user interface.
• Test - Previews the zoom area as it would be displayed during screen blanking.
• Tap Accept Zoom to keep the zoom area and finish, or
• Tap Reject Zoom to discard the zoom are and be returned to select a different
zoom area.
• Exit - Discards changes and returns to the ZoomZone user interface.