Honeywell Thor VM3 User Manual page 202

•
•
•
C:\myfile.ccf is the path and filename assigned to the file to settings read from the
device. The file must have a .ccf extension. If a file name is specified without a path, the
ccf file is saved to C:\Windows\DDF.
CCU.exe -import -*.* -C:\myfile.ccf
The example above imports settings from all available programs into a file named
myfile.ccf.
CCU.exe -import -RFTerm -C:\myfile.ccf
The example above imports RFTerm settings into a file named myfile.ccf.
CCU.exe -import -RFTerm-Win7 -C:\myfile.ccf
The example above imports RFTerm and Honeywell control panel settings into a file
named myfile.ccf.
Example 3: Apply settings
CCU.exe -apply -reset -e:\myfile.ccf
Use this command line example to read the settings from the specified ccf file and
apply them to the Thor VM3 running the CCC.
Where:
apply directs the CCU to read the settings from the ccf file and apply them to the system
registry.
reset is optional. When -reset is specified, all setting are reset to their default values
before the customized settings in the ccf file are applied. Any prior changes made to
these settings on the Thor VM3 are lost. If -reset is not specified, only the changed val-
ues in the ccf file are applied. Any other setting previously made on the Thor VM3 are
retained.
E:\myfile.ccf is the path and filename of the ccf file containing the changes to be
applied. If the path is not specified, the ccf file must be located at C:\Windows\DDF.
Note: After using the -apply parameter, the Thor VM3 must be rebooted for the changes to take
effect.
CCU.exe -apply -e:\myfile.ccf
The example above applies the settings from the ccf file to the device leaving all other
settings untouched.
CCU.exe -apply -reset -e:\myfile.ccf
192 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
RFTerm - RFTerm terminal emulation settings
VM3_Win7 - certain Honeywell specific control panels settings
*.* can be used to import settings from all available programs.