Link Settings - Honeywell Thor VM3 User Manual

Link Settings

The available network connections are shown on this tab:
The WLAN network can be enabled or disabled from this tab, however configuration
settings for the 802.11 a/b/g/n radio are set with the
Utility
The WWAN networks, if any, are shown on this page. A WWAN network is only displayed
if a SIM card has been installed for that network. The Thor VM3 supports two SIM cards.
See
enabled or disabled from this screen, however the connection is configured by tapping
the applicable Network Settings button.
To change the order (Priority) of the networks:
1. Select the desired network. When selected, the network has a green check mark to
2. Tap the Up or Down button to move the network in the desired direction.
3. Tap the Save button after the order is set.
To change the other options (Enable, Threshold, Dwell, Connect Attempts):
1. To enable or disable a carrier, tap the checkbox to the left of the carrier name. When
2. For other parameters, double tap the cell containing the value that is to be changed.
3. Enter the desired value.
238 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
(WCU).
Install SIM Card(s) for SIM card installation instructions. A WWAN network can be
the left.
checked, the carrier is enabled.
The value in the cell can now be edited.
WLAN Wireless Configuration