Configuration Cloning Utility Command Line Interface - Honeywell Thor VM3 User Manual

5. Tap Registry > Import.
6. When prompted to Default all Non-Configured Parameters:
•
•
•
7. Reboot the Thor VM3 for the new settings to take effect.

Configuration Cloning Utility Command Line Interface

Note: The CCU GUI must be closed before launching the command line interface.
To launch the Client Configuration Utility from the command line, select
Programs > Accessories and right click on the Command Prompt icon. Select Run as
administrator.
It is necessary to open the command window as an administrator because
the CCU must be able to access and make changes to the Windows registry.
The command utility can be run from the installed location (C:\Program Files\Honey-
well\Configuration Cloning Utility) or in portable mode (such as from a USB drive).
When running in portable mode copy the following files to the USB drive:
•
•
•
A batch file (.bat) can be created to run the CCU commands.
Refer to the examples below to use the command line.
Example 1: Launch GUI
CCU.exe
If ran with no parameters, the GUI CCU interface is opened.
Example 2: Import settings
CCU.exe -import -[programs] -C:\myfile.ccf
Us this command line example to import the current settings from the Thor VM3 run-
ning the CCU.
Where:
import directs the CCU to read the settings from the system registry.
[programs] is replaced by one or more of the following programs from which to import
settings, separated by an asterisk (*):
Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Tap Yes to set all parameters not configured in the ccf file to defaults on the
destination device.
Tap No to apply the values from the ccf file and leave all other parameters as-is on the
destination device.
Tap Cancel to exit with no changes to the destination device.
Configuration Cloning Utility.exe (from installation directory)
PrivateKeyLoaded.dll (from installation directory)
ccf file(s) (from C:\Windows\DDF or other user-specified folder)
(Start) > All
191