Honeywell Thor VM3 User Manual page 94

60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Side of Lid)
These instructions are for use with
Enhanced Dock
This option requires DC/DC external power supply Honeywell Part no. 9000313PWR-
SPLY.
Shown With Lid Attached
•
If the DC/DC power supply does not have screws in the side of the lid, see
Vehicles (50-150 VDC Power Supply, Screws on Top of
Caution: For installation by trained service personnel only.
Caution: Usage in areas where moisture can affect the power supply
Caution: Use caution when routing the power cable. See
84 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
only.
Lid is secured with screws on the
side of lid.
connections should be avoided. The power supply should be
mounted in a dry location within the vehicle or placed in a
suitable protective enclosure.
Cautions.
VM1D Standard Dock
Shown With Lid Removed
• Input and output connector blocks
under lid.
• One positive (Vin+), negative (Vin-)
and ground (
input block.
• One positive (Vo+) and negative
(Vo-) connection in output block.
Lid).
and VM3D
) connection in
60-144 VDC
Power Cable