Honeywell Thor VM3 User Manual page 140

6. Carefully lift the front panel away from the device.
7. Position the replacement front panel so wiring connector on the back of the front
8. Gently press the front panel into place.
9. Tighten the sixteen (16) captive M3 screws. In the order shown in the top figure
10. Reinstall the Thor VM3 in the dock.
11. When the Thor VM3 is placed in the powered dock, the UPS battery automatically
12. Restart the Thor VM3.
13. If adding or removing a defroster, update the Thor VM3 configuration by selecting
14. Close any open control panel windows.
15. If the replacement touch screen contains a resistive touch screen, perform a
16. The Thor VM3 is ready for use.
130 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Wiring Connector
on Thor VM3
panel lines up with the connector on the Thor VM3.
above, use a #2 Phillips bit and torque the screws to 7 ± 0.5 inch pounds.
reconnects.
Screen Control. It may be necessary to change the control panel to Large Icon or
Small Icon view before selecting Screen Control. Tap the Detect Defroster button
and follow any on-screen prompts.
Screen Calibration.
Wiring Connector
on Front Panel
Touch