Honeywell Thor VM3 User Manual page 96

Hide thumbs Also See for Thor VM3:
Table of Contents

Advertisement

6. Connect the stripped end of the positive wires (red and red/white twisted together)
7. Connect the stripped end of the negative wires (black and black/white twisted
Note: The input block has V
The output block has V
8. Connect the ground (green) wire from the Thor VM3 to the GND terminal on the
9. Route the wiring from the DC/DC power supply to the vehicle's electrical system. Do
10. Strip the wire ends and connect to the input side of the DC/DC power supply.
11. Use looms and wire ties to secure all wiring as shown.
12. Reattach the cover with the screws.
13. Connect the DC/DC power supply to the vehicle's electrical system as directed
Caution: For battery powered vehicles:
Caution: For internal combustion engine powered vehicles:
14. While observing the
ATTENTION: For uninterrupted power, electrical supply connections should not be
made at any point after the ignition switch of the vehicle.
86
Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
to the output block. See
together) to the output. See
+, V
IN
O
input side of the DC/DC power supply.
not connect to vehicle power at this time.
below:
V
+ is connected to battery positive.
IN
Vi
- must be connected to battery negative.
N
GND must be connected to the vehicle chassis ground.
V
+ is connected to battery positive.
IN
Vi
- is connected to battery negative.
N
GND is connected to the vehicle chassis ground, which can also be battery negative.
possible to the actual battery terminals of the vehicle. When available, always
connect to unswitched terminals in the vehicle fuse panel, after providing proper
fusing.
Power Cable
Identification.
Power Cable
- and GND terminals.
IN
+ and V
- terminals.
O
Fuse Requirements
connect the power cable as close as
Identification.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents