Honeywell Thor VM3 User Manual page 169

Auto-On
Select the Auto-On power plan when it is desired that the Thor VM3 power on when
external power is connected.
In Auto-On mode, the Thor VM3 is turned On by the presence of external power with no
user interaction required. Ignition input is ignored when Auto-On Mode is enabled.
Note: When the UPS battery has been depleted or disconnected (the Thor VM3 is first powered
out of the box, the front panel has been replaced, etc.) power the Thor VM3 manually by
pressing the power button. After the initial power up, the Thor VM3 powers on
automatically when power is attached and Auto-On mode is enabled.
The following default timeouts are used in the Auto-On power plan.
Dim the display
Turn of the display
Put the computer to sleep
Hibernate after
Auto-On Behavior
When the Auto-On power plan is selected and external power is present the Thor VM3
behaves as described below. If external power is not present, refer to the
Thor VM3 behavior.
Thor VM3 is Off
Conditions
The Thor VM3 is Off and gets external power, such as
•
•
•
Result
The Thor VM3 boots. Once booted the Thor VM3 follows the Auto-On power plan with
timers reset after the boot completes.
Thor VM3 is On
Conditions
The Thor VM3 is On and gets external power, such as
•
•
•
Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Thor VM3 is installed on a powered Smart Dock with the dock power switch On
Thor VM3 is already mounted to a dock and external power is applied to the dock
Thor VM3 is already mounted to a dock and the dock power switch is turned On
Thor VM3 is installed on a powered Smart Dock with the dock power switch On
Thor VM3 is already mounted to a dock and external power is applied to the dock
Thor VM3 is already mounted to a dock and the dock power switch is turned On
Never
30 minutes
Never (see note)
300 minutes
Never
1 minute
Never (see note)
20 minutes
UPS section for
159