Table of Contents
Advertisement
Operation
1.
2.
Recording Video
After you have installed the DVR following the instructions in
is ready to record. The DVR starts recording when you press REC and continues to
record until the hard disk drive is full if Record Mode - End of Disk is set to Stop. Or,
the DVR continues recording after the hard disk drive is full if Record Mode - End of
Disk is set to Overwrite. It does this by recording over the oldest video.
Although you will be able to record without changing the unit from its original factory
settings, you will want to take advantages of the DVR's many tools. See
Configuration
Rev 1.00
After you have the camera at the desired settings, press SPOT. The PTZ Preset
dialog box displays.
Select the number you want to assign to the preset and then press
virtual keyboard to enter the preset name. Press REC to load the PTZ preset
and the Preset View dialog box displays. Select the desired preset and press
load the preset.
for detailed descriptions of the recording mode options.
Note
The DVR is not recording if only the red LED on the REC
button is lit. When the DVR is set for Time-lapse or Event
recording, the red LED on the REC button indicates the unit is
ready to record. A red dot appears on the monitor when the
clock reaches a scheduled recording time and the DVR starts
recording video.
81
. Use the
Chapter 2,
Installation, it
Chapter 3,
Document 900.0258
09/04
to
Advertisement
Table of Contents
