Figure 3-53 Clip Copy Screen - Honeywell HRHD4+ User Manual

Configuration
To select the data source to back up, highlight the first box on the top and then press
. A drop-down list of available data sources displays. You can select Local or
Archive.
To select the type of drive to use for clip copy, highlight the first box on the top and
then press
CD-RW, USB HDD, or USB Flash Memory. Place a check mark in the Audio
box to copy recorded audio with video.
You can define how much video to copy by changing the start and end times and dates.
You can also select which camera you wish to copy.
Highlight the File Name box and then press
Figure
automatically adds the camera number (for example, 01) and .exe to the file name. If
you want to save the file in a specific folder, enter the folder name followed by a / (for
example, folder/filename).
After you have given the video a file name, highlight Start and then press
clip copy. When you select IDE CD-RW or USB-CD-RW, the DVR displays the
drive capacity, the clip size, and asks if you want to continue.
When more than two USB hard disk drives are installed on the DVR, the following
USB Device Selection screen displays.
Rev 1.00
Figure 3-53 Clip Copy Screen
. A drop-down list of available drives displays. You can select from IDE
Note To copy clips using the USB CD-RW, there must be two or
fewer external SCSI hard drives connected to the DVR. To
copy clips using the internal CD-RW drive, there must be three
or fewer external SCSI hard drives connected to the DVR.
3-7). Enter a file name for the video you are copying and select Close. The DVR
. A virtual keyboard displays (see
72
to start
Document 900.0258
09/04