Table of Contents
Advertisement
Configuration
camera displayed full screen while displaying the cameo window as a PIP
(picture-in-picture), or displaying the cameras in a grid pattern with the bottom right
window as the cameo.
3.
4.
Spot Monitoring Setup Screen
Use this screen (MENU
dwell time for each camera displayed on the spot monitor. You can also turn event
monitoring on and off.
1.
2.
Rev 1.00
Note
Sequence cannot be used in the 4x4 display mode of the
16-channel, 3x3 mode of the 9-channel, or the 2x2 mode of the
4-channel DVR.
Highlight the box beside Event Monitoring and then press to toggle between
On and Off. When it is On, the video of the lowest camera number among
cameras associated with the event-detected sensor will be displayed in
full-screen on the main monitor during the preset dwell time.
Highlight the box beside Event Monitoring Dwell Time and then press
You can adjust the event monitoring dwell time from 3 to 60 seconds.
Figure 3-42
Highlight the box beside Sequence Dwell Time and then press
adjust the sequence dwell time from 3 to 60 seconds.
Highlight the box beside Event Monitoring and then press
between On and Off. When it is On, the video of the lowest camera number
among cameras associated with the event-detected sensor will be displayed in
full-screen on the spot monitor during the preset dwell time.
Display
Spot Monitoring) to adjust the display
Spot Monitoring Setup Screen
60
.
. You can
to toggle
Document 900.0258
09/04
Advertisement
Table of Contents
