Table of Contents
Advertisement
Configuration
Table 3-2
Status
S.M.A.R.T. Alert
High Temperature
Not installed
The Cº field displays the temperature of the storage device.
The Usage field displays the device usage.
Caution
The DVR can be set to react to storage problems by activating an internal buzzer or
external alarms, and/or notifying a remote site. Highlight the box beside Storage
Problem Action: Alarm Out/Notify and then press
alarm output terminal that you want to associate with the storage problem event,
and/or Notify.
Rev 1.00
Storage Screen Status Options
Note
After the S.M.A.R.T. Alert message displays, we recommend
you replace the hard disk drive, usually within 24 hours.
Note
When the device is an IDE hard disk drive, you can change its
usage to either Rec. On or Rec. Off.
When the device is a SCSI hard disk drive, you can change its
usage to either Extension or Archive.
A "–" displays when connecting a hard disk drive that was
previously used for something else. In this situation, device usage
can be changed as desired usages; for example, Extension to
Archive or Archive to Extension. However, changing the
device usage causes the stored data on the device to be
lost.
34
Description
S.M.A.R.T. monitoring has detected a fault
condition.
S.M.A.R.T. monitoring has detected that the
storage device temperature exceeded the preset
temperature threshold.
The storage device is not installed.
to select from Beep, the
Document 900.0258
09/04
Advertisement
Table of Contents
