Table of Contents
Advertisement
Configuration
Configuring Recording Settings
Your DVR offers a variety of flexible recording modes:
•
•
•
Highlight Record Mode, Time-Lapse Record or Pre-Event Record in the
Record menu and then press
Record Mode Setup Screen
Access the Record Mode Setup screen (MENU
then press
Rev 1.00
Note
Pressing REC on the front of the DVR causes the red LED to
light and indicates the DVR is ready to record. However, this
does not mean the DVR is recording. The DVR records video
based on the parameters such as schedule and events defined
during configuration.
You can set it up to record all the time or to only record events.
It can be set up to continue recording after the hard disk drive is full by
recording over the oldest video.
You can set it up to alert you when the hard disk is full and stop recording.
. The Record Mode Setup screen displays.
Figure 3-27
. The following recording setup screen display.
Record Mode Setup Screen
46
Record
Record Mode) and
Document 900.0258
09/04
Advertisement
Table of Contents
