Table of Contents
Advertisement
Configuration
Refer to
you have copied.
Caution
Rev 1.00
Note
You cannot end the clip copy process during CD burning.
Appendix B, Review Video Clips
Note
During clip copy, you cannot change the system date and time,
shut the system down, switch to the Quick Setup mode, clear
all data, or change the system setup from a remote site.
Do NOT disconnect the USB cable or the power from the
external drive while copying clips. If the external drive is shut
down or the USB cable is disconnected while copying clips, the
DVR system may not work normally or the external
drive could be damaged, and you will get an error message
the next time you try to copy clips. You will need to power
down the DVR and restart it to get rid of the error message.
After the file system of the USB-IDE hard disk drive has been
corrupted, this error message cannot be dismissed. Even after
restarting the DVR, it may automatically restart while preparing a
clip copy. You must recover the file system using the recovery
program, or you must reformat the hard disk drive.
74
for instructions on how to review the images
Document 900.0258
09/04
Advertisement
Table of Contents
