Operation
The front panel controls are described in
Turning on the Power
After you have installed the DVR following the instructions in
is ready to record.
Live Monitoring
As soon as the DVR completes its initialization process, it will begin showing live video
on the attached monitor and playing live audio through the attached speaker. The
default mode is to display all cameras at the same time. Pressing any camera button
causes that camera to display full screen. It displays live video and plays live audio until
the user enters another mode.
Press DISPLAY to cycle the DVR through the different display formats.
You can set the DVR to display the event-detected video in full screen on the monitor
during the preset dwell time when there is an Event. The video of the lowest camera
number among cameras associated with the event-detected sensor displays and the
DVR returns to the previous screen format after event monitoring dwell time. While
the event monitoring is activated, the monitoring for all other subsequent events is
ignored. Pressing any individual camera button or DISPLAY during event monitoring
releases the current event monitoring and displays the selected camera or returns to
the previous screen format.
Pressing SEQUENCE causes the cameras to display sequentially on the monitor.
When in one of the multi-view formats, pressing this button causes the DVR to cycle
through user-defined screen layouts (page sequence), or the bottom, right screen to
Rev 1.00
Figure 4-1
DVR Front Panel (16-Channel Shown)
78
Chapter 3,
Configuration.
Chapter 2,
Installation, it
Document 900.0258
09/04