Table of Contents
Advertisement
Configuration
Pre-event Record Setup Screen
When the DVR is in the Event Record mode it is possible to have it record images
before the event occurs. Use the Pre-event Record screen to define how to handle
pre-event recording. Access the Pre-event Recording Setup screen (MENU
Record
screen displays.
You can turn individual cameras On or Off for pre-event recording. You can set the
image speed from 0.1 to 60 ips NTSC (50 ips PAL), and image quality from High,
Standard, and Low.
You can set the amount of time to record prior to the event by adjusting the Dwell
Time. You can set the Dwell from 1 to 300 seconds.
Rev 1.00
Pre-event Record) and then press
Figure 3-30
Pre-event Record Setup Screen
Note
When the DVR is in the Time-Lapse mode, it ignores the
pre-event settings and follows the time-lapse settings
50
. The Pre-event Record Setup
Document 900.0258
09/04
Advertisement
Table of Contents
